3D PRINTED RC CAR HUMMER H2 SUT


3d printed RC model of Hummer H2 SUT(pickup)!

A special feature of the model is that it uses metal gears and drive shafts inside the transmission and axles! You will no longer have problems with the breakage of 3D printed components. And you will not need to look for a way to make a conversion to install metal components! Everything is already included in the basic version!

All the necessary information for building the model, such as a list of non-printed parts for purchase, a list of fasteners, some characteristics and features of the model, you can find in the assembly instructions for this model: Here

You need 3.0 - 3.1 kg filament to print all the details for this model. The archive contains a folder with individual parts, and also a folder with parts combined into small groups, which can simplify the preparation of parts for printing for you. All groups are numbered in the order recommended for printing. You can start assembling the model while printing the parts!  The minimum required print area is 180x180x180mm. Some print groups are too big for 180x180mm printers, so if you have a printer like that, you need to print these parts from individual parts folder! Some individual parts are too large for 180x180mm printers, so you will need to print these parts from the Alternative Parts folder.

All parts for the model are designed to be printed with minimal using or no support material. Check out the printable parts list Here!

Model characteristics:

- RC model, 1 : 8.5 scale 

- Realistic exterior look, Detailed interior

- Openable Hood, doors, tailgate

- 182 printing parts, 49 printing groups

- 3kg filament

- Can be printed with 180x180mm printers

- Length ~546mm

- Width ~ 260/295mm(without/with mirrors)

- Height ~ 232mm

- Ground clearance ~ 52mm

- Wheelbase ~ 366mm

- Track ~ 218mm


For more sizing information, see the assembly instructions at the link above!

Pay attention! If you are printing parts from a folder with individual parts, then it does not contain some parts for the right side. Therefore, if you cannot find some part for the right side, then just make a mirror copy, the part for the left side, in your slicer!

If you have questions regarding this model, you can ask them using one of the methods on the Contacts page.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Related Products