3D Printed RC Car buggy "Hummgy"

This is a 3D printed radio-controlled buggy "Hummgy". This is a fast model to build. You need 1.7 - 1.8 kg of filament to print all the details for this model.  The archive contains a folder with individual parts, as well as a folder with parts combined into small groups, which can simplify the preparation of parts for printing for you. The minimum required print area is 180x180x180mm. Several printed groups may not fit on a 180x180mm bed, so you need to print the details of these groups from the individual parts folder.

The model uses a metal transmission from Axial SCX10 and metal gears and axle drive shafts from Axial Wraith.

You can find a list of print parts and some recommendations for print settings here.

Assembly instructions, a list of parts to buy and a list of fasteners can be found here.

It is highly recommended to read the instructions before starting the project !!!

Video of model ride 1 https://youtu.be/s5eClkI70SY

Video of model ride 2 https://youtu.be/l_MQF1rV8ts

Video of model ride 3 https://youtu.be/GidpzdiwsZg

Video of model ride 4 https://youtu.be/XUigQsWVfHI

Model characteristics:

- Scale 1 / 8.5

- Length 493mm

- Width ~ 280mm

- Height ~ 220mm

- Wheelbase ~356mm

- Front track ~242mm

- Back track  ~242mm

- Ground clearance ~65mm

- 4x4

Pay attention! If you print details from the individual details folder, it does not contain some details for the right side. Therefore, if you cannot find some part for the right side, then just make a mirror copy, the part of the left side, in your slicer!

If you have questions regarding this model, you can ask them using one of the methods on the Contacts page.