SPARE TIRE CARRIER FOR 3D PRINTED HUMMER


Compatible with all types of bodies, but can be installed only on civillian type of rear bumper!

To fit the lower part to the bumper:
2pcs M3x12 screws
1pc M3x8 screw

To install the top part:
1pc M3x10 screw + washer
1pc M5x35 Hex bolt + M5 nut.
I recommend cutting the bolt down to 32mm.

You also need 6pcs magnets 3x3x3mm.

I have a Facebook group, if you have any questions you can ask them there https://www.facebook.com/groups/an3drc

Write a review

Note: HTML is not translated!
    Bad           Good