2 DOOR PICKUP CONVERSION KIT

  • 2 DOOR PICKUP CONVERSION KIT

This is a kit for converting your 3D printed Hummer H1 into a 2 door Pickup version. If you are tired of your Hummer H1 4 door Pickup, Slantback or Hummer H1 Wagon, then you can use this set to convert them to the 2 door Pickup version!

To convert, you need to remove the body from the chassis, disassemble the rear part of the body, and then follow the instructions for assembling the 2 door Pickup body: link

Attention! Details named "Fender rear left" and "Fender rear right" are the same for the 2 door Pickup and 4 door Pickup versions. Therefore, if you have a 4 door Pickup version, then you do not need to print them again.

More photos of the 2 door Pickup version you can see on his page.

Or in my instagram: https://www.instagram.com/ant.nesh/

I have a Facebook group, if you have any questions you can ask them there https://www.facebook.com/groups/an3drc

Attention! Many details on the right side are mirrors of the left side. So if you can't find a part for the right side in the archive, just make a mirror copy of the left part in your slicer!

Write a review

Note: HTML is not translated!
    Bad           Good

Related Products